Страница 2 от 2

МнениеПубликувано на: Съб 29, Мар, 2008 2:36
от phantomlord
След рестарт е нормално да се зареди отново модула, който си махнал с rmmod. За да не става така, трябва да го включиш в "черния списък":
Blacklisting kernel modules

Sometimes it may be necessary to blacklist a module to prevent it from being loaded automatically by the kernel and udev. One reason could be that a particular module causes problems with your hardware. The kernel also sometimes lists two different drivers for the same device. This can cause the device to not work correctly if the drivers conflict or if the wrong driver is loaded first.

You can blacklist a module using the following syntax: module_name.blacklist=yes. This will cause the module to be blacklisted in /etc/modprobe.d/blacklist.local both during the installation and for the installed system.

МнениеПубликувано на: Съб 01, Юни, 2013 9:03
от jannishan213
Bus 002 Device 002: ID 07d1:3c09 => http://cateee.net/lkddb/web-lkddb/RT2870.html => rt2870sta
rt2800usb is loaded and conflicts with rt2870sta on Slitaz-4.0 2.6.37 kernel
Stop networking:
# /etc/init.d/network.sh stop
Unload both wireless modules:
# modprobe -r rt2800usb
# modprobe -r rt2870sta
Load the correct module:
# modprobe rt2870sta
Start networking:
# /etc/init.d/network.sh start